Solvent Based Water Repellent

Primer water repellent for the protection of porous walls

This water repellent is used to protect any kind of surfaces with pore and no alkaline without modifying their original aspect.
It is the ideal water- repellent which does not modify the original aspect but which prevents form the damage and the dirt caused by the weather, specially the caused by the ice.
It is made by water- repellent agents which prevent from the humidity (mold, rust and saltpeter), leaving clean the supports and keeping the supports clean.
It is does not become a film so it is permeable to the steam, allowing the surface to breathe.
Aspect Slightly milky liquid
Finishing Transparent
Specific weight 1,00 gr./cc.
Performance 2 – 5 m2 / lt (it depending of the state)
Total drying time Totally conditioned for the temperature, the surface and HR
Repainting Minimum: 8 hours; Maximum: No limit
Diluent Product ready for the use
Presentation 1 Lt., 5 Lt. and 15 Lt. containers
Conservation Keep away from extreme temperatures

The product is ready for the use, it must not be diluted, and it can be applied using any conventional method, brush, roller, spray gun, (do not use high pressure (< 3 bars), etc. The surfaces to be treated must be clean of salt, fat, completely free of moisture and foreign elements (new mortars leave completely, set 30 days approximately), apply in a uniform way by all the wall to avoid the appearance of uneven areas after rain; the number of hands depends on the porosity of the facade. Normally is sufficient with two hands. It should be applied at temperatures between 0°C and 35°C.